Specifications
Page 6-8 105SL Maintenance Manual 32056L Rev. 2 12/4/01
SECTION 6 OPTION KITS
44. Reconnect the power cable to the power source. Place the power switch in the On (I)
position.
45. Perform a PAUSE Key Self Test and observe the tracking of the liner. If the liner does
not track properly, proceed to “Adjusting the Roller Adjust Plate.”
5HFRQILJXUHWKH3ULQWHUIRU3HHO2SHUDWLRQ
1. Enter the Configuration mode by pressing the Setup/Exit key at the Printer Ready
display.
2. Press Next/Save until you get to Print Mode.
3. Press (+) or (–) key until you select PEEL-OFF.
4. Pressing the Setup/Exit key to leave the Configuration mode. Press the (+) or (–) key to
select Permanent. Press Next/Save to accept and make permanent.
$GMXVWLQJWKH3ODWHQ6XSSRUW%UDFNHW
If the liner is tracking off to one side, perform the following procedure to position the roller
adjust plate.
1. Refer to Figure 6-7. Loosen, but do not remove, the two screws holding the platen
support bracket to the side plate.
NOTE: Moving the bracket toward the front of the machine moves the label
backing material toward the main frame. Moving the bracket toward the
rear of the machine moves the label backing away from the main frame.
2. Adjust the bracket position as required and tighten the screws.
Figure 6-7. Platen Support Bracket Adjustment
Lower
Roller
Screws
Side Plate
Platen
Support
Bracket