Specifications

32056L Rev. 2 12/4/01 105SL Maintenance Manual Page 1-7
DESCRIPTION OF EQUIPMENT SECTION 1
(/(&75,&$/5(48,5(0(176
• Universal power supply with power factor correction 90-264VAC, 48-62Hz.
• Power Consumption
Idle = 19 W
Printing = 180 W (printing pause test label at speed A)
• Agency approvals: UL 1950, CISPR 22 (class B), IEC 950, 801-2, -3, and -4 standards,
CSA 950,Canadian Doc. (class A), FCC (class A), CE compliance
29(59,(:2))81&7,2162)0$-25$66(0%/,(6
3ULQW0HFKDQLVPDQG3ULQWKHDG
The print mechanism (see Figure 1-2) carries the printhead and has mechanical devices that
allow the printhead to be adjusted for optimum print quality. The printhead is an electrical part
that causes the printing to be done. The Zebra 105SL printer features a thin film printhead with
E
3®
Element Energy Control.
0HGLDDQG5LEERQ6HQVRUV
There are several sensors mounted in the 105SL printer that monitor the presence of ribbon and
media and signal the processor. The media sensors are shown in Figure 1-3 and Figure 1-4.
Table 1-7. Environmental Operating Ranges
Temperature
Thermal Transfer: +40°F to +104°F (+5°C to +40°C)
Direct Thermal: +40°F to +104°F (+5°C to +40°C)
Storage -40°F to +140°F (-40°C to +60°C)
Non-condensing
relative humidity
Operating 20% to 85%
Storage 5% to 85%
Figure 1-2. 105SL Printhead
Printhead
Mechanism
Assembly
Do Not Loosen
These Screws !!
Printhead
Mounting
Screw
Printhead
Data
Connector
Printhead
Alignment
Slots
Printhead
Power
Connector
Printhead
Resistance
Label
Power Cable
Locking Tab