Specifications

Page 1-6 105SL Maintenance Manual 32056L Rev. 2 12/4/01
SECTION 1 DESCRIPTION OF EQUIPMENT
* Media registration and minimum label length are affected by media type and width, ribbon type, print speed,
and printer mode of operation. Performance improves as these factors are optimized. Zebra recommends
always qualifying any application with thorough testing.
Table 1-6. Media Specifications
Minimum label length*
Tear-off 0.7
″ (18 mm)
Peel-off 0.5
″ (13 mm)
Cutter 1.5
″ (38 mm)
Rewind 0.25
″ (6 mm)
Total media width (label + liner, if any)
Minimum 0.79
″ (20 mm)
Maximum 4.52 mm (115 mm)
Total thickness (includes liner, if any)
Minimum 0.003
″ (0.076 mm)
Maximum 0.012
″ (0.305 mm)
Roll media core inside diameter 3
″ (76 mm)
Maximum roll diameter 8.0
″ (203 mm)
Inter-label gap
Minimum 0.079
″ (2 mm)
Preferred 0.118
″ (3 mm)
Maximum 0.157
″ (4 mm)
Maximum internal fanfold media pack size (label + liner) L x W x H
8.0
″ x 4.5″ x 4.5″
(203 mm x 114 mm x 114 mm)
Ticket/tag sensing notch L x W 0.12
″ x 0.25″ (3 mm) x (6 mm)
Ticket/tag sensing hole diameter 0.125
″ (3 mm)
Effective leading edge registration accuracy*
Vertical 0.050
″ (±1.3 mm)
Horizontal 0.050
″ (±1.3 mm)
Additional
specifications for
black mark sensing
Mark length (measuring
parallel to label/tag edge)
Minimum 0.12
″ (3 mm)
Maximum 0.43
″ (11 mm)
Mark width (measuring to
perpendicular label/tag edge)
Minimum 0.43
″ (11 mm)
Maximum Full media width
Mark location
Marks must be located within 0.040
″
(1 mm) of the inside media edge.
Mark density >1.0 Optical Density Unit (ODU)
Maximum density of the back of the media on
which the black mark is printed
0.5 ODU