Specifications

32056L Rev. 2 12/4/01 105SL Maintenance Manual Page 4-93
PREVENTIVE AND CORRECTIVE MAINTENANCE SECTION 4
12. Reconnect the power cable to the power source. Place the power switch in the On (I)
position.
13. Enter Printer Configuration and select MARK for sensor type.
0HGLD&RYHU5HSODFHPHQW
1. Refer to RRP No. 1 on page 4-10 and place the power switch in the Off (O) position
and disconnect the AC power cord. Disconnect the data cables.
2. Open the media cover.
3. Refer to Figure 4-72. Remove and discard the four screws that attach the media cover
to the main frame of the printer.
4. Remove the media cover.
5. Position the replacement media cover on top of the printer main frame as shown.
6. Secure the new media cover with four screws provided in the kit.
7. Remove the media panel from the old media cover, and attach the media panel to the
new media cover with four hex nuts.
8. Close the new media cover.
9. Reconnect the data cables and the power cord.
10. Reconnect the power cable to the power source. Place the power switch in the On (I)
position.
NOTE: It is a good practice to keep the media cover closed while the printer is
operating. Keeping the cover closed keeps the printhead cleaner,
increases its service life, and maintains the highest print quality. The
printer operates more quietly and stays cleaner with the cover closed. If
the cover is open, it is more likely that the printer can be disturbed by a
passer-by.
Figure 4-72. Media Cover Replacement
Allen Screws (4)
Media Cover
Hex Nuts (4)
Media Panel