Specifications

32056L Rev. 2 12/4/01 105SL Maintenance Manual Page 4-91
PREVENTIVE AND CORRECTIVE MAINTENANCE SECTION 4
10. Ensure that the peel roller extends through the bearing in the side plate, and secure
with the C-clip.
11. Ensure that the platen roller extends through the bearing in the side plate, and secure
with the washer and C-clip.
12. Refer to RRP No. 11 on page 4-26 and install the rewind drive belt.
13. Refer to RRP No. 9 on page 4-23 and install the main drive belt.
14. Refer to RRP No. 10 on page 4-25 and adjust the tension on the rewind drive belt.
Refer to RRP No. 8 on page 4-22 and adjust the tension on the main drive belt.
15. Reinstall the DC power supply or the AC/DC power supply, depending on configuration.
16. Reinstall the electronics cover.
17. Open the printhead and reinstall media and ribbon. Close the printhead.
18. Reconnect the data cables and the power cord.
19. Reconnect the power cable to the power source. Place the power switch in the On (I)
position.
20. Refer to “Printhead Adjustments” on page 4-30 and perform all the procedures to
achieve acceptable print quality.
Figure 4-70. DC Stepper Motor Removal and Installation
Main Frame
Grommet
Connector
Stepper Motor
Electrical Lead
Stepper Motor
Screws (4)
POWER
TAKE LABEL
ERROR
CHECK RIBBON
CANCEL
FEED
PAPER O UT
PAUSE
DATA
PREVIOUS
NEXT/SAVE
SETUP/EXIT
Stepper Motor Housing
Side
Plate