Specifications

Page 4-90 105SL Maintenance Manual 32056L Rev. 2 12/4/01
SECTION 4 PREVENTIVE AND CORRECTIVE MAINTENANCE
NOTE: After the side plate is reinstalled, there are many parts that need to be
reinstalled and a series of adjustments that need to be made. Do not
tighten any screws until all of the screws are installed.
3. Insert the bearings for the platen roller and peel roller into the side plate.
NOTE: As the side plate is attached, ensure that the print mechanism pivot bar is
through the wear plate and that the platen roller, peel roller, and pivot
shaft extend through the correct holes in the side plate.
4. Refer to Figure 4-69. Attach the side plate to the stepper motor housing by installing
screw 1 loosely.
5. Loosely install screws 2 through 6.
6. Align the side plate to its original position and tighten screws 1 through 6 to 16.5–
17.0 inch-pounds (1.8–2.0 N
m).
7. Align the remaining rollers and the tear/peel bar with their respective holes in the side
plate. Install screws 7 through 11 and tighten.
8. Reinstall the wave washer and printhead lever onto the pivot shaft. Tighten the
retaining screw 12 so it threads into the pivot shaft.
9. Refer to Figure 4-4 or Figure 4-5. Route the stepper motor electrical lead and
connector through the white plastic clamp. Secure the clamp with the hex nut.
Reconnect the lead.
Figure 4-69. Side Plate Removal and Installation
POWER
TAKE LABEL
ERROR
CHECK RIBBON
CANCEL
FEED
PAPE R OU T
PAUSE
DATA
PREVIOUS
NEXT/SAVE
SETUP/EXIT
7
12
8
1
4
Detail A
6
5
Stepper Motor Housing
Side Plate
9
10
Detail A
3
11
12
7
8
Wave
Washer
Pivot Shaft
Printhead
Lever
2