Specifications

32056L Rev. 2 12/4/01 105SL Maintenance Manual Page 4-89
PREVENTIVE AND CORRECTIVE MAINTENANCE SECTION 4
10. Refer to Figure 4-69. Remove screw 12, the printhead lever, and the wave washer, as
shown in Detail A.
NOTE: To ensure that the side plate is reinstalled in the exact position, paint two
thin lines from the side plate to the stepper motor housing.
11. On the media side of the printer, remove screws 1 through 11 to free the side plate from
the motor housing.
12. Remove the side plate.
13. Refer to Figure 4-4 or Figure 4-5. Remove the hex nut and open the white plastic
clamp that holds the stepper motor electrical lead. Disconnect the stepper motor
electrical lead.
14. Remove the four screws that attach the motor to the main frame.
15. Remove the old motor with its electrical lead.
,QVWDOOWKH5HSODFHPHQW'&6WHSSHU0RWRU
1. Refer to Figure 4-70. Pop out the old grommet and install the new grommet. Feed the
motor power cable through the grommet. Turn the split in the grommet away from the
large opening.
2. Secure the replacement motor to the main frame with four screws. Torque the mounting
screws to 15-16 inch-pounds (1.7–1.8 N
m).
Figure 4-68. Freeing Side Plate for Removal
C-Clip
Peel/Tear-Off Bar
Platen Roller
Bearing
Side
Plate
Main
Frame
Washer