Specifications
Page 4-80 105SL Maintenance Manual 32056L Rev. 2 12/4/01
SECTION 4 PREVENTIVE AND CORRECTIVE MAINTENANCE
10. Tighten the two set screws to secure the pulley.
11. Reinstall the rewind drive belt. Refer to RRP No. 10 on page 4-25 to adjust the tension
on the rewind drive belt.
12. Reinstall the main drive belt. Refer to RRP No. 8 on page 4-22 to adjust the tension on
the main drive belt.
13. Reinstall the DC power supply or the AC/DC power supply, depending on configuration.
14. Reinstall the electronics cover.
15. Reconnect the data cables and the power cord.
16. Reconnect the power cable to the power source. Place the power switch in the On (I)
position.
3LYRW%DU3ULQWKHDG/HYHUDQG7RJJOH5HSODFHPHQW
1. Refer to RRP No. 1 on page 4-10 and place the power switch in the Off (O) position
and disconnect the AC power cord. Disconnect the data cables.
2. Open the media cover.
3. Open the printhead and remove the media and ribbon. Close the printhead.
4. Refer to RRP No. 2 on page 4-12 and remove the electronics cover.
5. See Figure 4-61 and loosen the screw that retains the printhead lever.
6. Remove the printhead lever and the wave washer.
Figure 4-60. Peel Roller Pulley Replacement
Set Screws
Idler
Gear
Stepper Motor
Pulley
Rewind Drive Belt
Peel Roller Pulley
Media Take-Up
Pulley