Specifications

32056L Rev. 2 12/4/01 105SL Maintenance Manual Page 4-79
PREVENTIVE AND CORRECTIVE MAINTENANCE SECTION 4
16. Reconnect the power cable to the power source. Place the power switch in the On (I)
position.
3HHO5ROOHU3XOOH\5HSODFHPHQW
1. Refer to RRP No. 1 on page 4-10 and place the power switch in the Off (O) position
and disconnect the AC power cord. Disconnect the data cables.
2. Refer to RRP No. 2 on page 4-12 and remove the electronics cover.
3. For printers with configuration number 10500-0
XXX-XXXX or 10500-1XXX-XXXX,
refer to RRP No. 3 on page 4-13 and remove the DC power supply.
or
For printers with configuration number 10500-2XXX-XXXX or 10500-3XXX-XXXX,
refer to RRP No. 5 on page 4-16 and remove the AC/DC power supply.
4. Refer to RRP No. 9 on page 4-23 and remove the main drive belt.
5. Refer to RRP No. 11 on page 4-26 and remove the rewind drive belt.
6. Refer to Figure 4-60 and loosen the two set screws securing the peel roller pulley to the
peel roller shaft.
7. Slide the peel roller pulley off the shaft.
8. Orient the replacement pulley so the set screws align with the flats in the shaft.
9. Slide the pulley all the way onto the shaft.
Figure 4-59. Media Take-up Pulley Replacement
POWER
TAKE LABEL
ERROR
CHECK RIBBON
CANCEL
FEED
PAP ER OU T
PAUSE
DATA
PREVIOUS
NEXT/SAVE
SETUP/EXIT
Media Take-Up
Pulley
E-Ring
Spacer
Flat Washer
Wave Washer