Specifications
Page 4-78 105SL Maintenance Manual 32056L Rev. 2 12/4/01
SECTION 4 PREVENTIVE AND CORRECTIVE MAINTENANCE
7. Reinstall the E-ring to retain the pulley.
8. Install the main drive belt. Refer to RRP No. 8 on page 4-22 and adjust the tension on
the main drive belt.
9. Reinstall the electronics cover.
10. Reconnect the data cables and the power cord.
11. Reconnect the power cable to the power source. Place the power switch in the On (I)
position.
0HGLD7DNH8S3XOOH\5HSODFHPHQW
1. Refer to RRP No. 1 on page 4-10 and place the power switch in the Off (O) position
and disconnect the AC power cord. Disconnect the data cables.
2. Refer to RRP No. 2 on page 4-12 and remove the electronics cover.
3. For printers with configuration number 10500-0
XXX-XXXX or 10500-1XXX-XXXX,
refer to RRP No. 3 on page 4-13 and remove the DC power supply.
or
For printers with configuration number 10500-2XXX-XXXX or 10500-3XXX-XXXX,
refer to RRP No. 5 on page 4-16 and remove the AC/DC power supply.
4. Refer to RRP No. 9 on page 4-23 and remove the main drive belt.
5. Refer to RRP No. 11 on page 4-26 and remove the rewind drive belt.
6. Refer to Figure 4-59 and use a screwdriver or pair of pliers and remove the E-ring.
7. Slide the spacer and the pulley off the shaft.
NOTE: Do not remove the flat washer and wave washer.
8. Slide the replacement pulley onto the media take-up shaft.
9. Slide the spacer back onto the shaft.
10. Reinstall the E-ring to retain the assembly.
11. Reinstall the rewind drive belt. Refer to RRP No. 10 on page 4-25 to adjust the tension
on the rewind drive belt.
12. Reinstall the main drive belt. Refer to RRP No. 8 on page 4-22 to adjust the tension on
the main drive belt.
13. Reinstall the DC power supply or the AC/DC power supply, depending on configuration.
14. Reinstall the electronics cover.
15. Reconnect the data cables and the power cord.
WARNING:
WEAR PROTECTIVE EYE WEAR WHEN REMOVING E-RINGS, C-CLIPS,
SNAP RINGS AND SPRINGS. ALL OF THESE ARE UNDER TENSION AND
COULD FLY OFF WHILE BEING REMOVED.