Specifications

32056L Rev. 2 12/4/01 105SL Maintenance Manual Page 4-75
PREVENTIVE AND CORRECTIVE MAINTENANCE SECTION 4
5. Remove the two hex studs holding the serial interface connector and the two screws
holding the parallel interface connector to the back of the printer.
6. Refer to Figure 4-57. Remove the hex nut holding the ground lead from the power entry
module to the printer chassis. Pull the wires off the power inlet module and the power
switch.
7. Refer to Figure 4-56. Remove the two Phillips screws holding the back panel to the
aluminum plate.
8. Remove the three Phillips screws holding the back panel to the printer.
9. Slide the rear panel assembly out and away from the printer.
10. Remove the two screws and AC power cable connection (power entry module).
11. Refer to Figure 4-57. Squeeze the top and bottom of the power switch module to
release it from the back panel. Remove the module from the panel.
12. Discard old rear panel.
Figure 4-56. Rear Panel Fasteners
AC Power
On/off Switch
AC Power
Cable
Connection
Parallel
Connector
Interface
Phillips
Screws (3)
Phillips
Screw
Phillips
Screw
Phillips
Screws (2)
DB-25 Serial
Connector
Interface
3/16 Hex
Studs (2)
Allen
Screw
PCMCIA
AC Power
On/off Switch
AC Power
Cable
Connection
Printer Configurations
10500-0XXX-XXXX and
10500-1XXX-XXXX
Printer Configurations
10500-2XXX-XXXX and
10500-3XXX-XXXX
Parallel
Connector
Interface
Phillips
Screws (3)
Phillips
Screw
Phillips
Screw
Phillips
Screws (2)
DB-9 Serial
Connector
Interface
3/16 Hex
Studs (2)
Allen
Screw
PCMCIA