Specifications

32056L Rev. 2 12/4/01 105SL Maintenance Manual Page 4-71
PREVENTIVE AND CORRECTIVE MAINTENANCE SECTION 4
13. Secure the new media rewind spindle assembly with the E-ring.
14. Reinstall the rewind drive belt. Reinstall the main drive belt.
15. Refer to RRP No. 8 on page 4-22 and adjust the tension on the main drive belt.
16. Refer to RRP No. 10 on page 4-25 and adjust the tension on the rewind drive belt.
17. Reinstall the DC power supply or the AC/DC power supply, depending on configuration.
18. Reinstall the electronics cover.
19. Reinstall media and ribbon. Close the printhead.
20. Close the media cover. Configure the printer for media rewind.
21. Reconnect the data cables and the power cord.
22. Reconnect the power cable to the power source. Place the power switch in the On (I)
position.
Figure 4-53. Media Rewind Spindle Replacement
E-Ring
Spacer
Rewind
Pulley
Rewind
Spindle
Bearing
Housing
Flat Washe
r
Wave Washer
Screws (3)
Washers (3)