Specifications
Page 4-70 105SL Maintenance Manual 32056L Rev. 2 12/4/01
SECTION 4 PREVENTIVE AND CORRECTIVE MAINTENANCE
8. Connect upper sensor green and yellow leads to the main logic board. Connect lower
sensor red and black leads to the main logic board.
9. Close the white plastic clamps. Secure the clamps with hex nuts. Adjust the wire tie to
secure the wires.
10. Reinstall the electronics cover.
11. Refer to “Transmissive Media Sensor Position Adjustment” on page 4-35 and adjust
the position of the sensors.
12. Reinstall the media and ribbon. Close the media cover.
13. Reconnect the data cables and the power cord.
14. Reconnect the power cable to the power source. Place the power switch in the On (I)
position.
0HGLD5HZLQG6SLQGOH$VVHPEO\5HSODFHPHQW
1. Refer to RRP No. 1 on page 4-10 and place the power switch in the Off (O) position
and disconnect the AC power cord. Disconnect the data cables.
2. Open the media cover.
3. Open the printhead and remove the media and ribbon. Close the printhead.
4. Refer to RRP No. 2 on page 4-12 and remove the electronics cover.
5. For printers with configuration number 10500-0
XXX-XXXX or 10500-1XXX-XXXX,
refer to RRP No. 3 on page 4-13 and remove the DC power supply.
or
For printers with configuration number 10500-2XXX-XXXX or 10500-3XXX-XXXX,
refer to RRP No. 5 on page 4-16 and remove the AC/DC power supply.
6. Refer to RRP No. 6 on page 4-18 and remove the main drive belt. Refer to RRP No. 9
on page 4-23 and remove the rewind drive belt.
7. Refer to Figure 4-53. Use a screwdriver and/or a pair of pliers and remove the media
rewind spindle E-ring.
8. Remove the spacer, rewind pulley, flat washer, wave washer, and rewind spindle.
9. Remove the three screws with washers and the bearing housing.
10. Install the new bearing housing and secure with three screws and washers.
11. From the right hand side of the printer, install the new media rewind spindle.
12. On the left hand side of the printer, install the wave washer, the flat washer, the media
rewind pulley and the spacer.
WARNING:
WEAR PROTECTIVE EYE WEAR WHEN REMOVING E-RINGS, C-CLIPS,
SNAP RINGS AND SPRINGS. ALL OF THESE ARE UNDER TENSION AND
COULD FLY OFF WHILE BEING REMOVED.