Specifications

Page 4-66 105SL Maintenance Manual 32056L Rev. 2 12/4/01
SECTION 4 PREVENTIVE AND CORRECTIVE MAINTENANCE
14. Refer to Figure 4-4 or Figure 4-5. Carefully connect the remaining cables/connectors to
the power supply and verify proper placement and orientation.
15. Ensure that the power switch is in the Off (O) position. Reconnect the AC power cord.
Connect the power cord to a live AC source. Place the power switch in the On (I)
position. Enter configuration mode and set the printer for cutter mode. Save as
PERMANENT and place the power switch in the Off (O) position.
16. Test the cutter for proper operation. Load media and ribbon, hold in the PAUSE key
while turning the AC power on and run labels through the printer.
NOTE: If the media hits either cutter blade or the cutter does not cut through the
label material completely, perform “Upper Drive Arm Alignment,” before
completing the installation.
17. Reinstall the electronics cover.
18. Reconnect the data cables. Place the power switch in the On (I) position.
3ODWHQ3XOOH\5HSODFHPHQW
1. Refer to RRP No. 1 on page 4-10 and place the power switch in the Off (O) position
and disconnect the AC power cord. Disconnect the data cables.
2. Refer to RRP No. 2 on page 4-12 and remove the electronics cover.
3. Refer to RRP No. 9 on page 4-23 and remove the main drive belt.
4. Refer to Figure 4-48. Loosen two Allen set screws. Remove the old platen pulley
assembly.
Figure 4-48. Platen Pulley Replacement
Main Drive Belt
Stepper
Motor
Pulley
Platen Pulley
Assembly
Inside Peel/Tear-Off Bar
Mounting Screw
Ribbon Take-Up
Pulley
Set Screws