Specifications

32056L Rev. 2 12/4/01 105SL Maintenance Manual Page 4-65
PREVENTIVE AND CORRECTIVE MAINTENANCE SECTION 4
8. Tighten the two set screws that secure the lower drive arm to the shaft of the new cutter
motor.
NOTE: Make sure the notch in the main link points to the rear of the printer.
9. Attach the main link to the slotted link with the pivot pin and two E-rings.
10. Position the slotted link to the lower drive arm. Attach it with the E-ring and two
washers.
11. Connect the cutter motor power lead to cutter PCB connector J4.
12. Refer to “Lower Drive Arm Alignment” on page 4-60 and ensure that the alignment is
correct.
13. Reinstall the DC power supply or the AC/DC power supply, depending on configuration.
Ensure all wires are positioned away from any moving mechanical parts and are not
pinched or cut.
Figure 4-47. Cutter Motor Replacement
WARNING:
WEAR PROTECTIVE EYE WEAR WHEN REMOVING E-RINGS, C-CLIPS,
SNAP RINGS AND SPRINGS. ALL OF THESE ARE UNDER TENSION AND
COULD FLY OFF WHILE BEING REMOVED.
Cutter Motor
Shaft
Ferrite Ring
Grommet
Allen Screw
Motor Mounting
Allen Screws
Cutter Motor
Lower
Drive
Arm
Long Drive
Link
E-Ring
E-Ring
E-Ring
Pivot Pin
Bearing
Flat Washer
Mounting Post
Slotted Link
Clamp
Cutter Optical Sensor