Specifications

Page 4-58 105SL Maintenance Manual 32056L Rev. 2 12/4/01
SECTION 4 PREVENTIVE AND CORRECTIVE MAINTENANCE
4. Refer to Figure 4-43. Remove the E-ring that attaches the cutter main link to the
mounting pin in the cutter slotted link.
5. Remove the E-ring, flat washer and bearing that attach the cutter slotted link to the pin
on the lower drive arm.
6. Remove the E-ring and two flat washers that attach the cutter slotted link to the pivot
post.
7. Remove the slotted link.
8. Position the new slotted link as shown in Figure 4-43.
9. Attach the slotted link to the post pivot with two flat washers and the E-ring.
10. Install the bearing onto the lower drive arm. Place the slot in the slotted link over the
bearing. Secure the link with a washer and E-ring.
11. Attach the main link to the pivot pin of the new slotted link with the E-ring.
12. Apply a small amount of white lithium grease to the slot in the slotted link where the
bearing will ride. Remove any excess grease to prevent it from spreading to the cutter
optical sensor.
13. Reinstall the DC power supply or the AC/DC power supply, depending on configuration.
14. Reinstall the electronics cover.
15. Reconnect the data cables and the power cord.
16. Reconnect the power cable to the power source. Place the power switch in the On (I)
position.
&XWWHU3&%5HSODFHPHQW
1. Refer to RRP No. 1 on page 4-10 and place the power switch in the Off (O) position
and disconnect the AC power cord. Disconnect the data cables.
2. Refer to RRP No. 2 on page 4-12 and remove the electronics cover.
3. For printers with configuration number 10500-0
XXX-XXXX or 10500-1XXX-XXXX,
refer to RRP No. 3 on page 4-13 and remove the DC power supply.
or
For printers with configuration number 10500-2XXX-XXXX or 10500-3XXX-XXXX,
refer to RRP No. 5 on page 4-16 and remove the AC/DC power supply.
4. Disconnect all cables from the cutter PCB.
5. Refer to Figure 4-44 and remove the four screws that secure the cutter PCB to the
pems.
6. Remove and discard the old cutter PCB.
CAUTION:
OBSERVE PROPER ELECTROSTATIC SAFETY PRECAUTIONS WHEN
HANDLING ANY STATIC-SENSITIVE COMPONENTS SUCH AS PRINTED
CIRCUIT BOARDS AND PRINTHEADS.
7. Remove the new cutter PCB from anti-static bag and position it onto the pems.