Specifications

Page 4-52 105SL Maintenance Manual 32056L Rev. 2 12/4/01
SECTION 4 PREVENTIVE AND CORRECTIVE MAINTENANCE
5. For printers with configuration number 10500-0
XXX-XXXX or 10500-1XXX-XXXX,
refer to RRP No. 6 on page 4-18 and remove the Main Logic Board. Refer to
RRP No. 4 on page 4-14 and remove the AC power supply.
or
For printers with configuration number 10500-2
XXX-XXXX or 10500-3XXX-XXXX,
refer to RRP No. 7 on page 4-20 and remove the Main Logic Board.
6. Refer to Figure 4-38. Using a heavy pair of pliers, straighten out the mounting tabs of
the old media supply hanger.
7. Remove the old hanger.
,QVWDOO0HGLD6XSSO\+DQJHU
1. Refer to Figure 4-39. Insert the new media supply hanger from the right hand side of
the printer.
2. Using a heavy pair of pliers, bend the mounting tabs of the new media supply hanger.
3. For printers with configuration number 10500-0
XXX-XXXX or 10500-1XXX-XXXX,
reinstall the AC power supply.
4. Reinstall the main logic board.
5. Refer to Figure 4-4, the Printer Interconnection Diagram, and if you removed the
connectors from the main logic board, reconnect them. Make sure they go back into the
correct positions as shown.
6. Reinstall the electronics cover.
7. Open the printhead. Reload the ribbon and media. Close the printhead.
8. Close the media cover.
9. Reconnect the data cables and the power cord.
Figure 4-38. Media Supply Hanger Tabs
Mounting
Tabs