Specifications

Page 4-48 105SL Maintenance Manual 32056L Rev. 2 12/4/01
SECTION 4 PREVENTIVE AND CORRECTIVE MAINTENANCE
23. Replace the electronics cover.
24. Reinstall the media and ribbon. Close the printhead.
25. Close the media cover.
26. Reconnect the data cables and the power cord.
27. Reconnect the power cable to the power source. Place the power switch in the On (I)
position.
28. Perform a PAUSE Key Self Test and observe the tracking of the rewind drive belt and
the tracking of the label backing material. If you didn’t move the roller adjust plate, and
the label backing material was tracking correctly before, no further adjustment is
necessary. If you moved the roller adjust plate, you have to readjust it.
$GMXVWLQJWKH5ROOHU$GMXVW3ODWH
If the label backing material is tracking off to one side, perform the following procedure to
position the roller adjust plate.
1. Refer to Figure 4-34. Loosen, but do not remove, the two screws holding the roller
adjust plate to the side plate.
NOTES: Moving the roller adjust plate toward the front of the printer moves the
label backing material away from the roller adjust plate. Moving the roller
adjust plate toward the rear of the printer moves the label backing
material towards the roller adjust plate.
2. Move the roller adjust plate to compensate for the tracking.
3. Tighten the two head screws. Check label backing tracking again.
4. Repeat the procedure until the required results are achieved.
)URQW0HPEUDQH6ZLWFK5HSODFHPHQW
5HPRYHWKH2OG0HPEUDQH6ZLWFKDQG)URQW3DQHO
1. Refer to RRP No. 1 on page 4-10 and place the power switch in the Off (O) position
and disconnect the AC power cord. Disconnect the data cables.
2. Refer to RRP No. 2 on page 4-12 and remove the electronics cover.
3. For printers with configuration number 10500-0XXX-XXXX or 10500-1XXX-XXXX,
refer to RRP No. 3 on page 4-13 and remove the DC power supply.
or
For printers with configuration number 10500-2XXX-XXXX or 10500-3XXX-XXXX,
refer to RRP No. 4 on page 4-14 and remove the AC/DC power supply.
4. Refer to Figure 4-35 and remove the two ribbon cables from the LCD PCB at the top
back of the membrane switch panel.
5. If a ferrite bead is present, remove it by peeling it off the front panel.
6. Remove the nut securing the ground strap to frame.
7. Refer to Figure 4-36 and remove three nuts securing front panel. Remove front panel
with membrane switch attached.