Specifications

32056L Rev. 2 12/4/01 105SL Maintenance Manual Page 4-47
PREVENTIVE AND CORRECTIVE MAINTENANCE SECTION 4
14. Insert the long shaft end of the new peel roller through the hole in the main frame of the
printer. Work the short shaft end through the roller adjust plate.
15. Install a new bearing on the roller adjust plate with the flange of the bearing on the
outside of the adjust plate. Install the C-clip in the groove on the end of the roller shaft.
Slide the peel roller to the left to seat the bearing into the adjust plate.
16. Install a new bearing, the spacer, and the pulley on the long end of the platen roller.
17. Ensure that both set screws in the platen roller pulley align with flats on the platen roller
shaft.
18. Adjust the peel roller pulley on the left side of the peel roller shaft. Leave approximately
a 0.020
″ (0.5 mm) gap between the spacer and the peel roller pulley.
19. Tighten the two set screws to secure the pulley to the shaft.
20. Reinstall and adjust the rewind drive belt.
21. Reinstall and adjust the main drive belt.
22. Reinstall the DC power supply or the AC/DC power supply, depending on configuration.
Figure 4-34. Peel Roller Kit Parts
CAUTION:
Never reuse the old bearings. Use only the new bearings that were
provided with the replacement platen roller.
Bearing
Peel Roller
Roller Adjust
Plate
C-Clip
Bearing
Peel Roller
Pulley
Small Spacer
POWER
TAKE LABEL
ERROR
CHECK RIBBON
CANCEL
FEED
PAPE R OUT
PAUSE
DATA
PREVIOUS
NEXT/SAVE
SETUP/EXIT