Specifications

Page 4-46 105SL Maintenance Manual 32056L Rev. 2 12/4/01
SECTION 4 PREVENTIVE AND CORRECTIVE MAINTENANCE
18. Replace the electronics cover.
19. Reinstall the media and ribbon. Close the printhead.
20. Close media cover.
21. Reconnect the data cables and the power cord.
22. Reconnect the power cable to the power source. Place the power switch in the On (I)
position.
/RZHU3HHO5ROOHU
5HPRYHDQG5HSODFHWKH/RZHU3HHO5ROOHU
1. Refer to RRP No. 1 on page 4-10 and place the power switch in the Off (O) position
and disconnect the AC power cord. Disconnect the data cables.
2. Open the media cover.
3. Open the printhead. Remove the media and ribbon. Close the printhead.
4. Refer to RRP No. 2 on page 4-12 and remove the electronics cover.
5. Refer to RRP No. 9 on page 4-23 and remove the main drive belt.
6. For printers with configuration number 10500-0XXX-XXXX or 10500-1XXX-XXXX,
refer to RRP No. 3 on page 4-13 and remove the DC power supply.
or
For printers with configuration number 10500-2XXX-XXXX or 10500-3XXX-XXXX,
refer to RRP No. 5 on page 4-16 and remove the AC/DC power supply.
7. Refer to RRP No. 9 on page 4-23 and remove the rewind drive belt.
8. Refer to Figure 4-34 and loosen, but do not remove, the two set screws in the peel-
roller pulley assembly.
9. Slide the peel roller pulley off the peel roller shaft.
10. Remove the small spacer and bearing.
11. Push the lower peel roller to the right.
NOTE: Do not remove the roller adjust plate unless it is damaged, twisted, or
bent. If the adjust plate is removed, the alignment is lost, and an
adjustment procedure will need to be performed.
12. Remove the C-clip and bearing from the end of the platen roller.
13. Slide the peel roller as far to the left as possible to free the right end from the adjust
plate. Remove the peel roller.