Specifications

Page 4-32 105SL Maintenance Manual 32056L Rev. 2 12/4/01
SECTION 4 PREVENTIVE AND CORRECTIVE MAINTENANCE
5. Continue to make the small adjustments in both directions until the best quality is
achieved.
6. Enter the Configuration mode and decrease the darkness setting until the PAUSE Key
Self Test labels are a charcoal gray color.
7. Inspect the test labels for streaks, flowering and other print quality problems.
8. If required, adjust the printhead position until print quality problems are corrected.
9. Enter the Configuration mode and increase the darkness until the PAUSE Key Self Test
labels are printed at optimum resolution and contrast.
10. When acceptable print quality is achieved, tighten the four screws at the top of the
printhead.
11. Run additional PAUSE Key Self Test labels to verify proper positioning.
Figure 4-22. Printhead Adjustment
Note: The Ribbon Take-up Spindle
Is Not Shown In This Illustration
Loosen Four Screws Before
Adjusting Head Position
Strip
Plate
Wear Plate
Screws
Printhead Location
Adjusting Screws