Datasheet

74 Zebra P630i & P640i Card Printer Service Manual 980006-001 Rev. A
Installation and Setup
Changing the Printer Driver Options (Properties)
3. Calibration: Use these to adjust the mag head and printer sensors:
d. Mag Position Adjust
e. Mag Amplitude Adjust
f. Show Sensor Data
g. Flip Station Calibration: This routine determines the number of motor steps it takes
for the carrier to descend from the upper limit position to the lower limit position; i.e.,
the carrier’s physical end stop. This step count is saved in flash memory and is used to
drive the carrier down to the rest position before each and every flip station action.
h. Smart Card Calibration
i. Set Ribbon OEM (not used)
j. PH Pressure Calibration