Datasheet

72 Zebra P630i & P640i Card Printer Service Manual 980006-001 Rev. A
Installation and Setup
Changing the Printer Driver Options (Properties)
2.7.7.4 Control
The Control screen allows manual control over the printer. Some of these functions are similar
to the buttons on the front of the printer.
To access the Control screen, select Start > Printers and Faxes. Right click on the Zebra
P630i or Zebra P640i printer listing. Select Properties > Device Settings > Control
The following procedures can be performed from the Control screen (note that #1, #2 and #6
perform the same functions as the front panel buttons):
1. Advance Ribbon: Advances the print ribbon to the next set of panels. Use this after a
ribbon jam or when you load a new ribbon.
2. Advance Laminate: Advances the Laminate onto the rollers, under the flex guides. If the
laminate chips are already loaded, this will have no effect.
3. Run Clean Cycle: Activates the clean cycle to clean the sticky roller.
4. Print Test Card: This will print a test card containing driver configuration information
5. Clear Error: Clears some error conditions within the printer to allow printing to resume.
6. Print Control (Reprint Last Card and Copies): Activate a reprint of a card. You can also
set the number of copies to print.
7. Zero Buffer Count:
• Receive: If an error occurred, there may be a card image stuck in the receive buffer.
This clears the receive buffer if you do not want to print it.
• Print: If an error occurred, there may be a card image stuck in the print buffer. This
clears the print buffer if you do not want to print it.
8. Advanced Utilities... : See Advanced Utilities: on page 73.