Datasheet

66 Zebra P630i & P640i Card Printer Service Manual 980006-001 Rev. A
Installation and Setup
Changing the Printer Driver Options (Properties)
Flip Station Adjustment
To access the Flip Station Adjustment screen, select Start > Printers and Faxes. Right click on
the Zebra P630i or Zebra P640i printer listing. Select Properties > Device Settings > Printer
Adjustment > Flip Station Adjust...
1. Flip Station Max. Height Adjust: This parameter modifies the position to which the flip
station rises while flipping a card. Increasing this parameter forces the flip station to rise
to a higher position, while decreasing this parameter forces it to rise to a lower position.
Setting this parameter too high will result in undue wear and tear on the machine. Setting
it too low will result in failure to flip cards.
2. Insertion Height Adjust: This parameter modifies the position to which the flip station
rises while inserting a card into the laminator. Increasing this parameter forces the flip
station to insert at a higher position, while decreasing this parameter forces it to insert at a
lower position. Setting this parameter too high or too low will result in failures to insert
cards into the laminator.
3. Rest Position Adjust: This parameter modifies the position at which the flip station rests
when not flipping. Increasing this parameter forces the flip station to rest at a higher
position, while decreasing this parameter forces it to rest at a lower position. Setting this
parameter too high or too low will result in poor flips and dropped cards.
4. Card Position Adjust (Pixels): This parameter modifies the distance that the card carrier
drives in to the flip station. Increasing this parameter drives it further toward the
laminator, while decreasing this parameter doesn't drive it as far into the laminator. Setting
this parameter too high or too low will result in the card not being centered in the flip
station, leading to poor flips and dropped cards.