Datasheet

64 Zebra P630i & P640i Card Printer Service Manual 980006-001 Rev. A
Installation and Setup
Changing the Printer Driver Options (Properties)
Laminate Station Adjustment
To access the Laminate Station Adjustment screen, select Start > Printers and Faxes. Right
click on the Zebra P630i or Zebra P640i printer listing. Select Properties > Device Settings >
Printer Adjustment > Laminate Station Adjust...
The standard laminate patch length is 3.25” (82.55mm). Accurate positioning of the laminate
is important for practical and aesthetic reasons. The laminate must cover the entire image as
printed at the time of issuance, thus protecting critical data with a tamper-deterrent film.
If there is no magnetic stripe on the underside, a full width laminate should be used.
When using smart card or registered laminates and the length is too long or too short, use the
Length Adjust (mils) option to make length adjustments as required.
1. Length Adjust (mils) - This is the length of the laminate “patch”. If the patch is too long,
decrease this number, and vice versa.
2. Horizontal Offset (mils) - Adjusts laminate placement on the card.