Datasheet

62 Zebra P630i & P640i Card Printer Service Manual 980006-001 Rev. A
Installation and Setup
Changing the Printer Driver Options (Properties)
Print Station Adjustment
To access the Print Station Adjustment screen, select Start > Printers and Faxes. Right click
on the Zebra P630i or Zebra P640i printer listing. Select Properties > Device Settings >
Printer Adjustment > Print Station Adjust...
1. Offsets:
• Horizontal (X) Offset (pixels): This is the number of pixels to shift the image to
align it on the media. Increasing these values move the image left while decreasing
them moves the image right. This parameter can be used to center the image on the
card, or to align it with an edge.
• Vertical (Y) Offset (pixels): This is the number of pixels to shift the image to align it
on the media. Increasing these values moves the image down while decreasing them
moves the image up. This parameter can be used to center the image on the card, or to
align it with an edge.
2. Ribbon (Changing Ribbon values is not recommended.):
• Ribbon Position (mm): The sensor position adjust determines the distance from the
printhead dot line to the center of the gap interrupt sensor used to sense the ribbon
sync mark (or resin black panel). The sensor adjustment can be used to control the
offset from the start of a color panel to where the printing begins. To increase this
offset, make the sensor adjustment larger. The default value = 32.
• Ribbon Torque Adjust (%): This setting controls the torque of the ribbon
take-up motor. This value should always be set to 100%.
Important • Checking the box (circled in the figure below) will enable the greyed-out Print Station
Adjustment settings to be changed.
Important • Hold the card in the orientation that it exits the printer to determine which
adjustment to make: left = trailing edge, right = leading edge.Failure to do so will result in
the adjustments made being opposite of the desired result.