Datasheet

Installation and Setup
Setting up the Printer
980006-001 Rev. A Zebra P630i & P640i Card Printer Service Manual 31
Step 4. Push the stack back and forth to an angle of about 45° from vertical, so as to separate
all of the cards.
Step 5. Restore the card stack to its original squared-off condition, and place the cards in the
input hopper. The input hopper can hold up to 150 cards.
Step 6. Place the Card Weight on top of the card stack.
Step 7. Close the Card Feeder Cover.
Important • Static charges and edge burrs from the card die-cutting process can render
individual cards stuck together with significant adhesion force. These cards must
be
physically separated from each other before inserting into the Card Feeder; if not separated,
feeding or printing problems may occur.
Note • Cards with a Magnetic Stripe should be loaded with the stripe up and toward the front
of the printer, as shown in the figure below.
Mag Stripe