Datasheet

30 Zebra P630i & P640i Card Printer Service Manual 980006-001 Rev. A
Installation and Setup
Setting up the Printer
2.3.5 Loading Cards
The P630i and P640i Printers use standard ISO CR-80 PVC Composite cards. Do not use
cards with a paper or peel-off / adhesive backing.
• Size 54 x 86 mm (2.125 x 3.375 in) nominal (refer to ISO Specification for exact
dimensions and tolerances)
• Thickness .75 mm (.03 in) ± 10%, frequently referred to as “30 mil cards”
Step 1. Open the Card Feeder Cover; and if present, remove the Card Weight.
Step 2. Remove all wrapping from the card deck.
Step 3. Holding the card deck by the sides, hold it vertically against a flat surface such as a
desktop. If the deck is too thick for your hand to hold it comfortably, use about half a
deck at a time.
Important • Do not bend cards or touch the print surfaces as this can reduce print quality.
The surface of the cards must remain clean and dust free. Always store cards in an enclosed
container. Ideally, use cards as soon as possible.
Caution • Do not touch print surfaces of the cards; this can reduce print quality.