Datasheet

Installation and Setup
Setting up the Printer
980006-001 Rev. A Zebra P630i & P640i Card Printer Service Manual 29
2.3.4.6 Clearing the Laminate Channels
If your scissor cuts were neat enough to pass for machine-made cuts, continue with printing
cards. If not, do not waste a print cycle. Instead, remove the hand-cut patch(es) from the
Transfer Roller(s) as follows.
Removal of the Transfer Guide gives access to the Transfer Roller.
Step 1. Push the Retaining Spring to the left; pull the Transfer Guide straight out toward you.
Step 2. Remove and discard the laminate patch on the Transfer Roller. Never re-use!
Step 3. If needed, turn the Transfer Toggle to the
OPEN (vertical) position.
Step 4. Remove any laminate between the Transfer Rollers.
Step 5. Return the Transfer Toggle to the
RUN (horizontal) position. Note that the laminate
will not feed and place correctly if transfer toggle is not in RUN position.
Step 6. Re-install the Transfer Guide with its top edge above the laminate cutter guide. Pull
back the Retaining Spring while re-inserting the Transfer Guide, then release the
spring when the guide is pushed into place.
Step 7. Press the
LAMINATE button to load the Transfer Roller(s).
Note • Clearing procedures for the upper and lower laminate channels are similar. The upper
channel is shown here.
OPEN
RUN
Transfer
Guides
Retaining
Springs
Transfer Toggle
(Shown in normal
RUN Position; set to
OPEN only when
specified)
Important • Improper replacement of the Transfer Guide can cause laminate skewing and
mis-feeding. Be sure the Transfer Toggle is set to
RUN (horizontal). Take care to avoid
damaging the Transfer Roller ribs when replacing the Transfer Guide.
Observe the orientation of the Transfer Guides. If they are up-side down, you risk breaking
the rims on the rollers.