Datasheet

26 Zebra P630i & P640i Card Printer Service Manual 980006-001 Rev. A
Installation and Setup
Setting up the Printer
2.3.4.4 Using Partial-Width Laminate
Laminate come in three widths:
“Full-Width” laminate is 2 in (51 mm) wide. Full-width laminate is used on the front (i.e.,
upper) or back (i.e., lower) surface of the card.
“Partial-Width” laminate is available in two widths:
• 1.66 in (42mm) wide laminate is used for cards with a writable signature panel.
• 1.33 in (33 mm) wide laminate is used for cards with a magnetic stripe
If there is no signature panel or magnetic stripe on the back of the card, full-width laminate
would generally be used. These are shown in the following figure.
Step 1. Remove the Laminate Edge Guide from its “storage location” on the Laminator
Frame (it snaps out).
Note • Since partial-width laminates are only used for the back (i.e., lower) surface of the
card, this section only applies to the P640i Printer.
BACK OF CARD
BACK OF CARD
OF
OF
F
OF
FC
F C
2“
1.3”
1.66“
Laminate
Edge
Guide