Datasheet

24 Zebra P630i & P640i Card Printer Service Manual 980006-001 Rev. A
Installation and Setup
Setting up the Printer
Step 3. Pull out an inch or two of laminate past the lip of the cassette.
Step 4. Close the cassette by firmly pressing the “clamshell” together. You will hear a click
and feel a detent when the halves of the cassette seat together.
Step 5. Pull out a little more laminate between the lips of the cassette. If it suddenly stops,
resisting further pulling, a spring detent on the cassette has probably snagged a notch
on the end of the core. This means that the core was installed the wrong way. Open
the cassette and re-install the laminate.
Step 6. If the exposed end of the laminate is uneven or crinkled, cut it as square as you can
with scissors.
Step 7. Holding the cassette with the white roller up and pointing to your left, rotate the core
counter-clockwise to reel in the laminate. Stop when the end of the laminate is even
with the edge of the lips of the cassette.
Important • Check for overhang any time the cassette latch is opened or the cassette is
removed.