Datasheet

Installation and Setup
Setting up the Printer
980006-001 Rev. A Zebra P630i & P640i Card Printer Service Manual 23
2.3.4.2 Loading the Laminate Cassette(s)
Step 1. Remove the new roll of laminate from its packaging.
Step 2. Carefully following the guidelines in the following figure, place the laminate in
the Cassette.
.
Important • If you are using partial-width laminate in the Lower Cassette of a P640i Printer,
read the following section, Using Partial-Width Laminate, before proceeding with this
procedure. (Partial-width laminates are frequently used on the bottom surface of cards that
have a signature panel or a magnetic stripe.)
Important • The Upper and Lower Laminate Cassettes (the lower one only used on the P640i
Printer; the upper one used on both printers) are loaded differently, even though the Cassettes
appear virtually the same.
Note • Handle the laminate by the ends of the spools to avoid contaminating the laminate.
Upper Cassette
(Used on Both P630i and P640i)
White Roller Up
White Roller Down
Notched End of
Spool to Right
Notched End of
Spool to Left
Laminate Unrolls
Over Spool
Laminate Unrolls
Under Spool
Lower Cassette
(Used on P640i Only)
Labels inside
Cassettes
showing notch
orientation