Datasheet
Installation and Setup
Setting up the Printer
980006-001 Rev. A Zebra P630i & P640i Card Printer Service Manual 21
2.3.4.1 Removing the Laminate Cassette(s)
Step 1. The Laminate Cassette(s) (Upper only for the P630i Printer; Upper and Lower for the
P640i) are held in position by latch plates. The Upper Cassette is freed by turning its
Latch Plate counter-clockwise to a full vertical position; the Lower Cassette (only
present on the P640i Printer) is freed by turning its Latch Plate clockwise. Then pull
the cassette straight out from its holder.
Lower Laminate
Cassette Latch Plate
(P640i only)
Upper Laminate
Cassette Latch Plate
(P630i and P640i)
Heater
Cores
area
Hot Surface • If the printer has been in use, the Heater Cores area of the Laminator
may be hot.
Important • If either Latch Plate is opened, even unintentionally, the corresponding Cassette
must be removed and the Laminate reeled in.
Caution • If you feel resistance when removing the cassette, the laminate has likely run
out, leaving one end attached to the core and the other end under the cutter. Keep
tugging on the cassette, which will come free with a short tail of laminate.