Datasheet

Replacement Procedures
Magnetic Encoder
980006-001 Rev. A Zebra P630i & P640i Card Printer Service Manual 261
Step 2. If there is a magnetic encoder error, go into the Printer Driver; and perform the
Magnetic Encoder Amplitude Adjustment.
a. Select Start > Printers and Faxes, right click the Zebra Card Printer, and select
Properties from the pop-up menu.
b. From the Card Printer Properties screen, select Device Settings > Control >
Advanced Utilities.
c. Load a few magnetic stripe cards.
d. Click the Mag Amplitude Adjust button.
e. Observe the printer load a card and run the card back and forth under the
Magnetic Encoder.
Important • Do not perform Step 2 if the encoder successfully writes to the magnetic stripe
and all three tracks on the stripe read properly.