Datasheet

260 Zebra P630i & P640i Card Printer Service Manual 980006-001 Rev. A
Replacement Procedures
Magnetic Encoder
5.27.3 Adjustment
Step 1. After replacing the Magnetic Encoder, go into the Printer Driver; and perform the
Magnetic Encoder Position Adjustment.
a. Select Start > Printers and Faxes, right click the Zebra Card Printer, and select
Properties from the pop-up menu.
b. From the Card Printer Properties screen, select Device Settings > Control >
Advanced Utilities.
c. Load a few magnetic stripe cards.
d. Click the Mag Position Adjust button.
e. Observe the printer load, encode, and eject the card. Note that this is a one-time
setup when the starting position is stored in the firmware. It is not necessary
repeat this step unless the Magnetic Encoder is mechanically adjusted.