Datasheet

Replacement Procedures
Magnetic Encoder
980006-001 Rev. A Zebra P630i & P640i Card Printer Service Manual 259
5.27.2 Replacement
Step 1. Set the replacement Magnetic Encoder in place.
Step 2. Install the shoulder screws, nylon washers, compression springs, and flat washer.
Note that there is no flat washer on the left side.
Step 3. Remove the shim.
Step 4. Carefully pull the ground wire and cable & connector through the opening behind
the Hopper.
Step 5. Connect the Magnetic Encoder Connector to J14 on the Main PCBA.
Step 6. Connect the ground wire to the Frame.
Important • Use the 30-thousandths shim while installing the shoulder screws (and
associated hardware), then remove it once the screws are tightened.