Datasheet

Replacement Procedures
Magnetic Encoder
980006-001 Rev. A Zebra P630i & P640i Card Printer Service Manual 257
5.27 Magnetic Encoder
5.27.1 Removal
Step 1. Locate the Magnetic Encoder.
Step 2. If not already done, remove the Rear Cover (see Section 5.3) and the Main PCBA
(see Section 5.5).
Step 3. With a 5/64 hex driver, remove the shoulder screw, nylon washer, compression
spring, and flat washer from the right side of the Magnetic Encoder.
Step 4. With a 5/64 hex driver, remove the shoulder screw, nylon washer, and compression
spring from the left side of the Magnetic Encoder. Note that there is no flat washer
on the left side.