Datasheet

240 Zebra P630i & P640i Card Printer Service Manual 980006-001 Rev. A
Replacement Procedures
Heater Elements
Step 2. Slide the Heater Elements into place. Ensure the top and bottom heaters are in their
respective positions.
Step 3. With a TORX T10 driver, secure the three screws that hold each heater to the Frame.
The screws must not be too tight (tighten, then back off 1/2 turn).
Step 4. Connect the Heater Elements to the Main PCBA.
Step 5. Turn the printer around, and wipe away any Triflunox 722 that may have seeped out
of the front of the Laminator Heater Cartridge.
Note • In the next step, use the replacement screws that come in the Spare Parts Kit -- they
have a dry-to-the-touch film applied to the threads which lock and seal the screws in place.