Datasheet

16 Zebra P630i & P640i Card Printer Service Manual 980006-001 Rev. A
Installation and Setup
Setting up the Printer
2.3.2 Installing the Ribbon
2.3.2.1 Attach Take-Up Spool
Step 1. Attach the Ribbon Take-Up Spool by sliding it onto the Ribbon Take-Up Spindle and
pressing it straight back until in clicks into place.
The two figures below show the right and wrong ways to insert the printing ribbon on
either spindle.
Important • Make sure that the Ribbon Take-Up Spool is attached with its “toothed” end
toward the rear of the printer.
Right way: the clip is OVER the core. Wrong way: the core is not pushed fully against
the back side, resulting in a Y border on the
printed cards.