Datasheet

224 Zebra P630i & P640i Card Printer Service Manual 980006-001 Rev. A
Replacement Procedures
Ribbon Payout Spindle
5.20.2 Replacement
Step 1. Attach the Encoder Wheel to the replacement Spindle.
Step 1. Install the clutch parts in the order indicated.
Step 2. Slide the spindle, with the clutch parts installed, onto the spindle shaft.
Step 3. Loosely tighten the lock nut.
Step 4. Slide the Ribbon Encoder Sensor up and into its original position.
Step 5. With a 7/64 hex driver, tighten the two screws that hold the Ribbon Encoder Sensor
to the Frame.
Step 6. Install the RFID Antenna Cover. Note that the cover snaps in place.
Step 7. Set the torque of the clutch; see Section 5.20.3.
1 2 3 4 5 6 7 8 9