Datasheet

Replacement Procedures
Ribbon Encoder Sensor
980006-001 Rev. A Zebra P630i & P640i Card Printer Service Manual 221
Step 4. If not already done, remove the Rear Cover (see Section 5.3) and the Main PCBA
(see Section 5.5).
Step 5. From the rear of the printer, locate the Ribbon Encoder Sensor.
Step 6. Cut any associated cable ties to free the Ribbon Encoder Sensor.
Step 7. If not already disconnected, remove the RIBBON ENCODER Connector from J31
on the Main PCBA.
Step 8. From the rear of the printer, slide the Ribbon Encoder Sensor out of its access hole.
Step 9. Remove the Ribbon Encoder Sensor.