Datasheet

Replacement Procedures
Laminator Transfer Rollers
980006-001 Rev. A Zebra P630i & P640i Card Printer Service Manual 219
Step 5. With snap-ring pliers, remove the snap retaining ring and roller gear from the
transfer roller shaft.
Step 6. Push the shaft toward the front of the printer.
Step 7. With a TORX T15 driver, remove the two screws holding the Laminator Transfer
Roller to the shaft; see figure above.
Step 8. Remove the Laminator Transfer Roller from the shaft by pulling the shaft out,
toward the front of the printer.