Datasheet

210 Zebra P630i & P640i Card Printer Service Manual 980006-001 Rev. A
Replacement Procedures
Cleaning Encoder Sensor
5.16 Cleaning Encoder Sensor
Step 1. If not already done, remove the Rear Cover (see Section 5.3) and the Main PCBA
(see Section 5.5).
Step 2. From the rear of the printer, locate the Cleaning Encoder Sensor.
Step 3. With a Phillips #0 screwdriver, remove the two screws holding the Cleaning
Encoder Sensor to the Frame.
Step 4. Cut any associated cable ties to free the Cleaning Encoder Sensor.
Step 5. If not already disconnected, remove the CLEAN ENCODER Connector from J29
on the Main PCBA.