Datasheet

Replacement Procedures
Clean Roller
980006-001 Rev. A Zebra P630i & P640i Card Printer Service Manual 209
5.15.2 Replacement
Step 1. Install the rear torsion spring, encoder wheel, and sensor first; then install the
replacement Clean Roller.
Step 2. The Pivot Screw (left-side screw) must not be too tight (tighten, then back
off 1/2 turn).
Step 3. After installing the replacement Clean Roller, run a clean cycle.
Step 4. If the cleaning tape seizes, adjust the Pivot Screw 1/2 turn counterclockwise. Repeat
until the clean cycle becomes operational; see figure above.