Datasheet

196 Zebra P630i & P640i Card Printer Service Manual 980006-001 Rev. A
Replacement Procedures
Printhead Assembly
Step 3. Connect the cable to the replacement printhead, making sure it is seated properly.
Step 4. Install the back mounting screw. Note that the back screw is the shorter of the two
mounting screws.
Step 5. Install the front mounting screw.
Step 6. Ensure the front and back mounting screws are fully tightened.
Step 7. Loosely tighten the inside mounting screw.
Step 8. Pivot the head assembly forward to bring the angle adjust screw in contact with the
print head frame, then tighten inside mounting screw.
Step 9. Make sure the cable is not inhibiting free rotation of the Printhead about its pivot.
Step 10. Adjust the Printhead; see Section 5.13.3.
Caution • Make sure power is disconnected before working on the print head. Also note
that the head will likely be destroyed if power is reapplied while you are in process of
reconnecting the cable, or if the plug is not seated properly.
Inside Mounting
Screw
Access Hole for
Angle Adjust
Screw
Back Mounting
Screw
Front Mounting
Screw