Datasheet

190 Zebra P630i & P640i Card Printer Service Manual 980006-001 Rev. A
Replacement Procedures
Flip Station
5.10.4.14 Rest Position Adjust
This procedure adjusts how far down the carrier drives.
If the truck fails to pull the card out of the flip station after the flipping action, chances are:
1. The card position is wrong; see “Card Position Adjust” on page 191.
2. The carrier is not coming down all the way; repeat “Flip Station Calibration” on
page 187.
Another adjustment for this:
Step 1. Power down the printer, then power up and listen for the flip station reset action.
Step 2. Access the Flip Station Adjustment screen, select Start > Printers and Faxes. Right
click on the Zebra P630i or Zebra P640i printer listing. Select Properties > Device
Settings > Printer Adjustment > Flip Station Adjust...
Step 3. Open the main cover, then push gently down on the carrier (at the back, close to the
guide shaft). If there is any downward travel, increase the parameter (make it less
negative) -- but do not overdo it, because this will increase the reset noise and
potentially damage the carrier drive.