Datasheet

188 Zebra P630i & P640i Card Printer Service Manual 980006-001 Rev. A
Replacement Procedures
Flip Station
5.10.4.12 Max Height Adjust
The card carrier needs to move high enough to actuate the flipping mechanism, but should not
over-travel excessively.
To access the Flip Station Adjustment screen, select Start > Printers and Faxes. Right click on
the Zebra P630i or Zebra P640i printer listing. Select Properties > Device Settings > Printer
Adjustment > Flip Station Adjust...
Increase this parameter only if there is an occasional failure to flip.
Reduce this value if the carrier hits the upper bracket holding the guide shaft.
If the flip station is not flipping reliably, be sure it is a travel issue rather than anything else by
opening the printer cover and moving the flip station up by hand to activate the flip. If it
doesn’t flip, the mechanism itself is defective, so adjusting the height parameter will have
no effect.
If you overdo the height adjustment (i.e., sending the carrier too high), the U-shaped azimuth-
adjust molding may be driven off the end of its track. This causes the carrier to wobble as the
“U” re-engages on the way down.