Datasheet

186 Zebra P630i & P640i Card Printer Service Manual 980006-001 Rev. A
Replacement Procedures
Flip Station
b. With a 1/4” box wrench, adjust the front Flip Arm until it just misses the Platen.
Step 31. Install the Drive Motor.
a. Set the Drive Motor in place.
a. With a TORX T25 driver, lightly tighten the two screws holding the Drive Motor
to the Frame.
b. Ensure that the drive belt is aligned properly, around the drive motor pulley.
c. Manually rotate the drive motor to tighten the belt.
d. With a TORX T25 driver, fully tighten the two screws holding the Drive Motor
to the Frame.