Datasheet

Replacement Procedures
Flip Station
980006-001 Rev. A Zebra P630i & P640i Card Printer Service Manual 183
5.12.2 Replacement
Step 19. From the rear of the printer, install the Backplate by lifting it up and into the printer.
Ensure the two tabs at the top of the Backplate are on the outside of the support
beam on the front.
Step 20. Install (finger-tight) the two 5/16 screws that hold the Backplate to the Frame.
Step 21. With a Phillips #2 screwdriver, install the two screws holding the Backplate to the
Front Bezel.
Step 22. With a flat-blade screwdriver, tighten the two 5/16 screws installed in Step 20.
Step 23. From its highest point, slide the entire carrier assembly into the printer.
Step 24. Slide the shaft into position.
Step 25. Slide the carrier assembly down to the Platen.
Step 26. With a Phillips #0 screwdriver, tighten the screw that holds the shaft in place. The
screw is tightened onto the notch at the top of the shaft -- do not over tighten.
Note • For ease of handling, insert a card between the Flip Arms when installing the carrier
assembly in the printer.