Datasheet

176 Zebra P630i & P640i Card Printer Service Manual 980006-001 Rev. A
Replacement Procedures
RFID Antenna Assembly
5.10 RFID Antenna Assembly
Step 1. Locate the RFID Antenna Assembly (Antenna Cover and Antenna Flex Cable).
Step 2. Remove the Antenna Cover from the Payout Spindle. Note that the Antenna Cover
snaps in place.
Step 3. Separate the Antenna Flex Cable from the Antenna Cover.
Step 4. With a
TORX T25 driver, remove the two screws shown in the figure above. This
will loosen the cover plate and provide enough clearance to slide the Antenna Flex
Cable out of the Frame.
Step 5. If not already disconnected, remove the
RFID Connector from J45 on the
Main
PCBA.
Step 6. From the rear of the printer, slide the Antenna Flex Cable out of the Frame.
RFID Antenna
Assembly
Screws